Finished: https://drive.google.com/open?id=1c_PtZxywpZP3dTexfzcHzfpifIybaej2

Notes: This is a VERY large figure that will just barely fit on my 7.9" x 7.9" x 7.1" build area if I disable both Raft and Brim in CURA. Please verify your printer is large enough to handle it before you attempt to print.

Print Recommendations: Because the figure is so large, curling/warping is your enemy, especially since you probably won't be able to use a raft or brim. You're going to want to do everything you possibly can to prevent heat loss. and keep the roof and floor completely flat. I recommend spraying down a ton of non-aerosol hairspray, using a borosilicate glass plate if you have a heated bed, and if it's physically possible to do so, seal up your printer inside an enclosure, even if it's something you have to build yourself out of cardboard.

Color Recommendations: While I can't find color photos of the version of the Dalek Time Machine used in The Chase (the version in Dalek Masterplan was different), it appears that the inside of the arches were silver and the outsides were the same robin egg blue color as Dalek hemispheres from the same serial.